Design Graphics Engineering Technology

BACHELOR OF SCIENCE DEGREE (BS)

» Program Prerequisite: AAS degree in Design Graphics Engineering Technology from Weber State University or equivalent degree or coursework from an accredited AAS program.

 

» Minor: Not required.

 

» Grade Requirements: A grade of "C" or better in all DGET courses is required (a grade of "C-" is not acceptable) in addition to an overall GPA for all courses of 2.50 or higher. Also refer to the general grade requirements for graduation.

 

» Credit Hour Requirements: A total of 124 credit hours is required. for graduation. A total of 40 upper division credit hours is required (courses numbered 3000 and above.)

Advisement

All four-year design graphics engineering technology students are required to meet at least annually with a faculty advisor for course and program advisement. Call 801-626-6305 for more information or to schedule an appointment. Advisement may also be obtained in Engineering Technology, room 214.

Admission Requirements

Declare your program of study.  Refer to the Program Prerequisite above.  There are no additional special admission or application requirements for this program.

General Education

Refer to to General Requirements for Bachelor of Science degree requirements. TBE TE1700, Microcomputer Applications, will fill part of the Computer Literacy requirement and COMM HU2110 will fulfill both program and general education requirements.

Course Requirements for BS Degree

Design Graphics Engineering Technology Courses Required (34 credit hours)

• DGET 3100 Tool Design (3)
• DGET 3300 Graphical Kinematics & Animation (3)
• DGET 3400 Technical Illustration & Documentation I (3)
• DGET 3470 Applications in CAD (3)
• DGET 3640 Cost Estimation & Control (3)
• DGET 4350 Architectural Design (3)
• DGET 4400 Technical Illustration & Documentation II (3)
• DGET 4470 Advanced 3D CAD Modeling (3)
• DGET 4500 Pneumatic, Electrical & Hydraulic Applications (3)
• DGET 4600 Senior Project (2)
• DGET 4610 Senior Project (2)
• DGET 3890 or DGET 4890 Cooperative Work Experience (1-3)

Technical Electives (3 credit hours minimum)

Support Courses Required (10 credit hours)

• MFET 2300 Statics & Strength of Materials (5)
• MFET 3320 Machine Design (2)
• MFET 3550 Supervision Principles (3)

Suggested Course Sequence
The following suggest course sequence is provided to assist students in planning their schedules. Us this only as a guideline and be sure to consult with an advisor.

Weber State University 2009-2010 Catalog